On May 8, 2020, Yaskawa Electric (China) Co., Ltd. Automobile Management Department Xiangyuan Minister, After-sales Service Department Suda Section Chief, Automobile Management Department Zhou Hui, a group of 4 people visited Shanghai Jiesheng Robot Co., Ltd. Hongqiao Headquarters Participated in the Yaskawa Robot Sales Authorization Letter and After-sales Service Certification Bookmarking Ceremony, Shanghai Jiesheng Robot General Manager Chen Lijie and Yaskawa Electric Motors General Manager Xiangyuan conducted in-depth exchanges on the robot sales market for the next quarter, and Suda Section of the after-sales service department The leader reached a good consensus on better guaranteeing the later service of robots. The successful signing this time provides a strong guarantee for the in-depth cooperation between the two parties and lays a solid foundation for Shanghai Jiesheng Robot Co., Ltd. to better sell and serve Yaskawa robots and products.
Yaskawa robot troubleshooting:
When the Yaskawa robot cannot work normally, if there is an alarm signal from the robot itself, the operator can refer to the handling method in the instruction manual according to the specific alarm code on the teaching panel. Restart after eliminating the alarm.
After an instantaneous power failure of the Yaskawa robot resumes power supply, first check whether the air pressure is sufficient. If the air pressure reaches 5MPa, the robot can be turned on. At this time, if there is still a tube on the robot suction cup, the tube should be put down according to the manual operation method, and the robot should be taught back to the origin and then power on.
If the industrial robot has a pipe sucked on the suction cup, first manually move the robot to a suitable position to put down the pipe and then teach the robot back to the origin before starting. The method to release the vacuum is to first close the vacuum valve (OUT#1OFF), and then open the blow valve (OUT#20N). If the 0380 or 5040 error code appears after the power failure or the production is restarted after the power is turned on, follow the steps below to repair it:
1. Turn on the servo power
2. Press TEACH
3. Press CUSTOMER
4. Press F3 (SPECPT)
5. Press F1 (PSN CHG)
6. Press ENABLE
7. Press MODIFY
8. Press ENTER
9. Press F4 (CHECK)
Daily maintenance and inspection of Yaskawa robots
Daily inspection of robots is very important. Only by completing these tasks on time can the robot work properly.
Post time: Dec-15-2020
